Your current location：
PRODUCT DETAILS PRODUCT DETAILS
Fully automatic two station balancing machine.
Applicable scope: automobile electric motor, electric motor, electric motor, micro motor, etc.
The machine is divided into three types: single cutter shaft (A), double cutter shaft (B), and non-brush rotor special weight (C).
The graph shows: automatic two-station balancing machine (B)
introductiont
Product introduction
parameters
configuration parameter
| Technical parameters of BMDA-A0220-A/B in full automatic two - position balance machine. | Technical parameters of BMDA-A0220-C of full-automatic two-station balance machine (no-brush rotor special two station to weigh) | ||
| Test House | Cycle time | 8-12s（According to the actual wight of the rotor.） | 8-12s(According to the actual weight of the rotor.) |
| Retest precision | ±1.5mg | ±1.5mg | |
| Measuring speed | 1000～3000R/M | 1000～3000R/M | |
| Residual volume | G1-G6.3 | G1-G6.3 | |
| Rotor range | Rotor diameter | Φ15～Φ45mm；Φ40～Φ65mm；Φ60～Φ120mm | Φ15～Φ45mm；Φ40～Φ65mm；Φ60～Φ120mm |
| Rotor stack length | 20～100mm | 20～100mm | |
| Cutting mechanism | Correct way | Using milling | Milling/drilling |
| Rectified Linear Units | （A/B) | —— | |
| ※Tool optional | Alloy R, V, T - type milling cutter, alloy drill bit | Alloy milling cutter/alloy bit | |
| Main component | Pneumatic logic members | SMC | SMC |
| Electric control | Mitsubishi, Toshiba, omron, panasonic, schneider, Siemens | Mitsubishi, Toshiba, omron, panasonic, schneider, Siemens | |
| Sensor | Keenes, omron, ortux | Keenes, omron, ortux | |
| PLC | Omron | Omron | |
| Volume (length * width * height) |
1700mm*900mm*1600mm (※Depending on the workpiece, there will be differences.) |
1700mm*900mm*1600mm（※Depending on the workiece,there will bdifferences.) | |
| Weight | —— | 0.8T | 0.8T |
| Power | —— | 三相AC380V | 三相AC380V |
| Working air pressure | —— | 0.4-0.6Mpa | 0.4-0.6Mpa |
specifications
technical specifications
-
1. correction mode: V-shaped cutter milling, R-shaped cutter milling, T-shaped cutter milling, twist drill drilling.
2. assembly line optional: belt line, chain line, zigzag line, ring assembly line.
3.strong versatility, quick change, high efficiency and simple operation.
4. optional: single knife correction (d) double knife correction (s) push knife correction(t) (two rotating milling ccutters are installed on the same spindle)
5. vacuum cleaner
links
COPYRIGHT © Shanghai emperor Ann machinery equipment co., LTD. All rights reservedWebsite construction: an excellent network
Address:No. 168, zhongkai road, songjiang district, Shanghai
